Aftermarket parts for the Segway Villain are hard to find, and its factory radius rods are an easy upgrade. DRT's kit replaces the complete set with CNC-machined 6061-T6 billet hex bar rods on PTFE-lined left/right-hand rod ends. The rear suspension holds its geometry better under hard use.
Features and Benefits
- Complete set: replaces all factory radius rods.
- Adjustable: 3-piece PTFE-lined left/right-hand 5/8 in rod ends.
- Hex bar body: a wrench surface for locking the rod ends.
- Billet strength: aerospace-grade 6061-T6, made in the USA.
- Mil-spec anodize: machined pockets and laser engraving on the center toe link.
- Stainless spacers: 303 stainless rod end spacers.
Specifications, Materials and Finish
- Material: 6061-T6 billet aluminum, hex bar
- Rod ends: 3-piece PTFE-lined 5/8 in, left and right hand thread
- Spacers: 303 stainless steel
- Finish: Military Specification anodize
- DRT part number: 70010RR61201 (patent pending)
Fitment
| Year | Make | Model |
|---|---|---|
| 2022+ | Segway | Villain SX10 / SX10W (72 in) |
TRAILWORX Fitment Guarantee: fitment above is taken directly from DRT Motorsports. If you order the part listed for your vehicle and it does not fit, we will make it right with the correct part or a prepaid return, at no extra cost to you. Not sure about your trim? Send us your year, make, model and trim before you order and we will confirm it.
What's in the Box
- Complete radius rod set
- PTFE-lined 5/8 in rod ends
- 303 stainless steel rod end spacers
Who It's For and What Pairs Well
For Villain owners building for desert or dunes. Pair it with the DRT Segway Villain SX10/W 2022+ Rear Sway Bar Link Kit (M12).
Installation Notes
Copy each OEM rod length before removal and swap one rod at a time with the rear supported. After install, confirm every jam nut is tight and set with thread locker, and paint-mark each nut so movement is easy to spot. Inspect the jam nuts before every ride. Any change to radius rod or tie rod length changes camber or toe, so get a proper alignment after install and after any adjustment, then take a short test drive and recheck the hardware. Care: rinse sand and mud off the rod ends after rides and avoid blasting them with a pressure washer at close range. Check the rod ends for play at each service and replace any that feel loose.
Free shipping on this DRT Motorsports part from Trailworx UTV. DRT Motorsports designs and builds its UTV parts in Riverside, California.
- Manufacturer:
- DRT Motorsports
- source:
- drt_site
- drt_url:
- https://drtmotorsports.com/products/segway-villain-sx10w-72-billet-radius-rod-kit
- desc_status:
- written_2026-10-31
- price_basis:
- DRT retail 720.0; comp r1industriesoffroad.com 720.0
