The front of your CFMOTO UFORCE U10 Pro is all plastic and grille, and it's the first thing to hit brush, branches, and the occasional stump. This Front Bumper puts 1.75" steel tubing in front of all that so the bumper takes the hit instead of your bodywork. It's also designed to work with a winch, so you can add pulling power and protection in one setup.
Features and Benefits
1.75" Steel Tubing Up Front
The bumper is made of 1.75" diameter steel tubing, tough enough to handle bumps into stumps, rocks, and trees. It covers the entire front end, including your bodywork and grille. That keeps brush and branches from scratching up your factory plastics or jamming into the grille, where they can block airflow and cause heat problems.
Frame-Mounted for Strength
It mounts directly to the frame using factory mounting locations. Because it's tied into the frame and not the plastics, it stays solid even when you take a hard hit. It won't budge or rattle loose on rough trails.
Winch Ready
The bumper is designed to accommodate a winch, so if you want recovery capability up front, you can run both without fighting for space.
Powder Coat That Holds Up
A UV-resistant powder coat finish protects the steel from rust, corrosion, chips, and fading. Rain, creek crossings, and mud won't eat it up.
Looks Right on the Machine
The U10 Pro looks good from the factory, and this bumper's clean, sleek design gives it a tougher look without looking like an afterthought.
Fitment
| Year | Make | Model |
|---|---|---|
| 2025+ | CFMOTO | UFORCE U10 Pro |
| 2025+ | CFMOTO | UFORCE U10 Pro Highland |
| 2025+ | CFMOTO | UFORCE U10 Pro XL |
| 2025+ | CFMOTO | UFORCE U10 Pro XL Highland |
What's in the Box
- Front bumper (bolts to the factory frame mounting locations, no drilling)
Who It's For and What Pairs Well
Anyone who rides tight, wooded trails or works around brush and timber should have something protecting the front end. If you want the back end covered too, the matching rear bumper finishes the job. Underneath, a full skid plate protects the frame and drivetrain from rocks and stumps you can't see. Since the bumper is built to work with a winch, check our U10 Pro recovery gear and winches, and if you plow in the winter, look at the Plow Pro snow plow mount.
Install Notes
No drilling is required. The bumper bolts directly to the frame at the factory mounting points, so it's a quick install with basic hand tools. If you're adding a winch, it's easiest to mount the winch at the same time.
