On the 72 in Maverick X3, bent or stretched factory radius rods throw off rear alignment and handling. DRT's hex bar kit replaces the complete set with CNC-machined 6061-T6 billet rods. They are left/right adjustable on six PTFE-lined rod ends, and the hex body gives you a wrench surface when you lock them down.
Features and Benefits
- Complete set: replaces all factory radius rods on the 72 in X3.
- Fully adjustable: six 5/8 in PTFE-lined rod ends, three LH and three RH thread.
- Hex bar body: a wrench surface for locking the rod ends.
- Billet strength: aerospace-grade 6061-T6, made in the USA.
- Mil-spec anodize: machined pockets and laser engraving on the center toe link rod.
- Stainless spacers: 303 stainless rod end spacers.
Specifications, Materials and Finish
- Material: 6061-T6 billet aluminum, hex bar
- Rod ends: (6) 5/8 in PTFE-lined, (3) LH and (3) RH thread
- Spacers: 303 stainless steel
- Finish: Military Specification anodize; machined pockets and laser engraving on the center toe link
- Platform: 72 in Maverick X3
- DRT part number: 30010RR61201 (patent pending)
Fitment
| Year | Make | Model |
|---|---|---|
| 2017+ | Can-Am | Maverick X3 (72 in, 2-door) |
| 2017+ | Can-Am | Maverick X3 MAX (72 in, 4-door) |
Fitment note: DRT lists this kit for the 72 in X3 platform. Confirm your car's width before ordering.
TRAILWORX Fitment Guarantee: fitment above is taken directly from DRT Motorsports. If you order the part listed for your vehicle and it does not fit, we will make it right with the correct part or a prepaid return, at no extra cost to you. Not sure about your trim? Send us your year, make, model and trim before you order and we will confirm it.
What's in the Box
- Complete radius rod set
- (6) PTFE-lined 5/8 in rod ends
- 303 stainless steel rod end spacers
Who It's For and What Pairs Well
For X3 owners replacing bent rods or building for desert and dunes. Pair it with the DRT Can-Am Maverick X3 2017+ Dual Shear Radius Rod Plate or DRT Can-Am Maverick X3 2017+ Billet Radius Rod Plate with Tow Hook.
Installation Notes
Measure and copy each OEM rod length before you remove it, then swap the rods one at a time with the rear supported. After install, confirm every jam nut is tight and set with thread locker, and paint-mark each nut so movement is easy to spot. Inspect the jam nuts before every ride. Any change to radius rod or tie rod length changes camber or toe, so get a proper alignment after install and after any adjustment, then take a short test drive and recheck the hardware. Care: rinse sand and mud off the rod ends after rides and avoid blasting them with a pressure washer at close range. Check the rod ends for play at each service and replace any that feel loose.
Free shipping on this DRT Motorsports part from Trailworx UTV. DRT Motorsports designs and builds its UTV parts in Riverside, California.
- Manufacturer:
- DRT Motorsports
- source:
- drt_site
- drt_url:
- https://drtmotorsports.com/products/copy-of-canamx3-can-am-x3-2017-billet-aluminum-barrel-radius-rod-kit-black
- desc_status:
- written_2026-10-31
- price_basis:
- DRT retail 720.0; comp r1industriesoffroad.com 720.0
