Can-Am Maverick X3 Track Bars for 6" Lift, Front A-Arm Support, 64"

Running a 6" lift on top of 8" portals turns a Can-Am Maverick X3 into a barrel-club beast, but it also hangs a lot of weight and leverage on the front A-arms. Every mud hole and rut becomes a chance to bend them. These track bars brace the front suspension against that load, virtually doubling front suspension strength so you can hit bigger bumps with bigger tires and portals without crumpling your arms. They're designed for the X3 6" lift kit on 64" models.

Highlights

• Virtually doubles the strength of the front suspension
• Designed for the X3 6" lift kit
• 1.25" diameter steel bars with heavy-duty heims
• 1/8" steel frame mounting plate
• Double Axis technology for full travel without binding

Why a Lifted X3 Needs Them

A big lift and portals add weight at the hub and leverage on the A-arms. The more leverage, the more each hit tries to fold the arms back. Track bars tie the arms into the frame so loads are shared, protecting your investment and letting you ride the way that machine was built for.

Built to Double Your Strength

The bars are made from 1.25" diameter steel tubing with heavy-duty heim joints, and the frame mount uses 1/8" steel plate for a bulletproof connection point. Together they virtually double the strength of the front suspension.

Double Axis Technology

Track bars are tricky to design. Without precise placement, you give up strength, ground clearance, suspension travel, or all three. These use Double Axis technology to deliver full suspension travel without binding while maintaining true 3-point geometry for maximum strength and clearance.

Bolt-On Clamps

The clamps are big and beefy, and testing shows they won't break when properly installed, so no welding is needed. Even with their size, they only hang down a couple of inches to keep clearance loss to a minimum.

Features and Specs

• Virtually doubles front suspension strength
• Designed for the X3 6" lift kit
• 1.25" diameter steel bars
• 1/8" steel mounting plate
• Heavy-duty heim joints
• Clamp-on, no welding required
• Does not fit X RS or 72" models

Who They're For and What Pairs Well

These are for owners of 64" X3 models running the 6" lift from Can-Am Maverick X3 lift kits, especially with X3 portal gear lifts and big tires. Pair them with lift-length X3 axles and see more bracing in Maverick X3 suspension braces.

Fitment

For use with Can-Am Maverick X3 6" Lift Kit for

Note: Does NOT fit X RS or 72" models.

Installation

The clamps bolt on with no welding. Install them correctly per the instructions for full strength.

• Installation instructions (PGH8-RL-010, PDF)