Camber on the Pro XP rear is set by the upper radius rods, so that is where adjustment matters most. DRT's quick camber barrel rods replace the two OEM upper rods with CNC-machined 6061-T6 billet barrels that use left- and right-hand rod ends, so you can change camber on the car with a wrench. They are made to run with the factory lower high clearance rods.
Features and Benefits
- Quick camber changes: left- and right-hand threads adjust length without removing the rods.
- Billet barrels: aerospace-grade 6061-T6, made in the USA.
- PTFE-lined rod ends: 3-piece 5/8 in rod ends.
- Wrench notches: machined into each barrel.
- Stainless spacers: 303 stainless rod end spacers.
- Mil-spec anodize: with laser-engraved branding.
Specifications, Materials and Finish
- Material: 6061-T6 billet aluminum barrels
- Rod ends: 3-piece PTFE-lined 5/8 in, left and right hand thread
- Spacers: 303 stainless steel
- Finish: Military Specification anodize, laser engraved
- Position: rear upper radius rods only
- DRT part number: 20010RR31201 (patent pending)
Fitment
| Year | Make | Model |
|---|---|---|
| 2020+ | Polaris | RZR Pro XP (64 in, 2-door) |
| 2020+ | Polaris | RZR Pro XP 4 (64 in, 4-door) |
Fitment note: Upper rods only. DRT designed this kit to run with the OEM lower high clearance radius rods.
TRAILWORX Fitment Guarantee: fitment above is taken directly from DRT Motorsports. If you order the part listed for your vehicle and it does not fit, we will make it right with the correct part or a prepaid return, at no extra cost to you. Not sure about your trim? Send us your year, make, model and trim before you order and we will confirm it.
What's in the Box
- Upper radius rods (left and right)
- PTFE-lined rod ends
- 303 stainless steel rod end spacers
Who It's For and What Pairs Well
For Pro XP owners who want camber adjustment and stronger upper rods without replacing the full set. Add the DRT Polaris RZR Pro XP 2020+ 3-Piece Billet Radius Rod Reinforcement Plate to reinforce the plate the rods mount to.
Installation Notes
Replace one upper rod at a time with the vehicle supported, and set the new rod close to the OEM length before tightening. After install, confirm every jam nut is tight and set with thread locker, and paint-mark each nut so movement is easy to spot. Inspect the jam nuts before every ride. Any change to radius rod or tie rod length changes camber or toe, so get a proper alignment after install and after any adjustment, then take a short test drive and recheck the hardware. Care: rinse sand and mud off the rod ends after rides and avoid blasting them with a pressure washer at close range. Check the rod ends for play at each service and replace any that feel loose.
Free shipping on this DRT Motorsports part from Trailworx UTV. DRT Motorsports designs and builds its UTV parts in Riverside, California.
- Manufacturer:
- DRT Motorsports
- source:
- drt_site
- drt_url:
- https://drtmotorsports.com/products/drt-rzr-pro-xp-2020-billet-aluminum-barrel-quick-camber-upper-radius-rods
- desc_status:
- written_2026-10-31
- price_basis:
- DRT retail 250.0; comp r1industriesoffroad.com 250.0
