Can-Am Defender HD11 & Defender MAX HD11 Rear Windshield, 1/4" Polycarbonate, Dark or Light Tint, Scratch-Resistant Option, With or Without Snorkel, Made in USA

Run a front windshield by itself and the Defender HD11 pulls dust and mud into the cab from behind. A rear windshield stops that swirl, blocks wind and debris from the back, and is the first step toward a full cab for year-round riding.

Highlights

• Stops the dust suction caused by a front windshield alone
• Protects against flying mud and debris
• 1/4" polycarbonate, 250x stronger than glass and 25x stronger than acrylic
• Light or dark tint, plus a scratch-resistant option
• With or without snorkel versions
• Precision cut to the cage for a rattle-free fit
• Full-length bulb seals keep water and dust out
• Works with soft or hard tops
• Made in the USA; 1-year warranty

Choose Your Version

• Windshield Material: standard polycarbonate in dark or light tint, or scratch-resistant polycarbonate in light tint
• Model: with snorkel or without snorkel, to match your machine

Nearly Impossible to Crack

Polycarbonate takes branch and rock hits that would shatter glass, so the back of the cab stays protected.

Who It's For and What Pairs Well

For HD11 and MAX HD11 owners who run a front windshield or are building a full cab. Pair with a front windshield from Defender windshields, a roof from Defender roofs and doors from Defender doors.

FAQ

Do I need a roof?

Yes. A roof must be installed to mount this rear windshield.

Dark or light tint? Dark tint cuts glare from behind; light tint keeps the cab brighter.

The Dust Suction Problem

At speed, air rushes over a front windshield and creates a low-pressure pocket inside the cab. That pocket pulls dust and spray in from the open back, often making the cab dirtier than with no windshield at all. Closing off the back with a rear windshield stops the swirl and keeps the cab clean.

Standard or Scratch Resistant?

- Standard polycarbonate: tough, impact resistant and affordable - Scratch-resistant polycarbonate: adds a hard coat that resists scratches and stays clear longer Pick scratch resistant if you ride in brush or clean dust off often.

Care Tips

• Rinse with water before wiping to remove grit
• Use mild soap and a soft cloth
• Avoid ammonia-based glass cleaners

Fitment

Note: Must have an OEM or roof to install

Installation Notes

Fit the bulb seal, set the windshield against the rear cage and attach the clamps evenly.

• Installation instructions (RWS-CA-DEFXMR, PDF)
• Installation instructions (RWS-CA-HD11, PDF)