Can-Am Maverick X3 Full Windshield - 1/4" Clear Polycarbonate, Clamp-On by Evolution (2017-2019)

The Maverick X3 is fast, and at speed, dust and cold air hit the cab hard. This Evolution full windshield closes the front of the early X3 with 1/4 in. clear polycarbonate, a wide 48.8 in. sheet that covers the whole opening. It clamps on with four ABS clamps and a contoured rubber edge along the hood.

Why It Works on an X3

• Fits the 2017-2019 X3 Turbo, Turbo R, DS Turbo R and X RC Turbo, and the 2018-2019 X3 900.
• Wide 48.8 x 27.6 in. panel spans the X3 front opening.
• 1/4 in. polycarbonate is shatter-resistant and holds its shape at speed.

X3 Riding Tips

• On high-speed runs, a full windshield can pull dust back in from behind. A roof and rear dust panel help a lot.
• Rinse dust off before wiping, and use a plastic-safe cleaner.
• Check the clamps after the first ride, since the X3's stiff suspension can settle them.
• Keep a microfiber towel in the car for quick cleanups.
• Moto Alliance showed low stock at our last check, so we confirm availability when you order.

Evolution Windshield Specifications

• Type: front, full windshield
• Material: clear polycarbonate, 1/4 in. thick
• Light transmission: 93%
• Dimensions: 48.8 in. (L) x 27.6 in. (H) x 0.25 in.
• Listed weight: 35.2 lb
• Scratch and corrosion resistant
• Shock and stretch resistant
• Optical-grade polycarbonate for maximum visibility
• Thick rubber strip along the bottom edge buffers the hood and seals the gap
• High-strength ABS clamps grip the cage without scratching
• Extra-wide hook-and-loop (Velcro) straps hold the glass in place and make install quick

Fitment

Note: Moto Alliance lists 2017-2019 X3 models only. For a 2020 or newer Maverick X3, ask us before ordering.

What's in the Box

• Evolution full windshield (WP_FS_312)
• 4 ABS clamps with hook-and-loop straps
• Installation hardware and instructions

Who It's For and What Pairs Well

This windshield is for X3 owners who ride in cold weather, desert dust or rain, or who carry kids and want them out of the wind. See more X3 options in Can-Am Maverick X3 windshields and Maverick X3 recovery gear.

Installation Notes

Clean the cage where the clamps grip, set the windshield on the hood so the rubber strip is even, and install the four ABS clamps with the included hardware. Tighten evenly, left to right, until it is firm. The instructions ship with the windshield.