Polaris RZR XP Turbo S & XP 4 Turbo S Custom Cage Windshield Kit, Trim-to-Fit 28" x 40" Polycarbonate, BreezeRite 3-Position Vents, Hard Coat

Chopping the cage on a Polaris RZR XP Turbo S makes a great-looking build, but no stock windshield fits it anymore. This Custom Cage Windshield Kit solves that. The bottom is already shaped to the Turbo S hood and the panel matches the machine's width, while the top is left oversized so you can trim it to your cage. BreezeRite vents and a hard coating come standard.

Highlights

• Oversized 28" (H) x 40" (W) panel trims to fit your custom cage
• Bottom edge contoured to the Turbo S hood
• Injection-molded BreezeRite vents with three positions
• 1/4" polycarbonate: 250x stronger than glass, 25x stronger than acrylic
• XR Optic hard coating for scratch resistance
• Heavy-duty clamps and rubber bulb seal included
• Made in the USA

Made for One-Off Cages

Every custom cage is a little different, so this kit leaves the fitting to you where it matters. Trim the top to your cage line, then use the heavy-duty clamps to mount it wherever your tubes run. The bulb seal keeps moisture out along the hood.

Airflow on Your Terms

The BreezeRite vents let you choose fully closed, half open or fully open, so you can bring in air on a hot day without taking the windshield off.

Tough and Scratch-Resistant

Polycarbonate soaks up impacts from large trail debris that would break glass or acrylic. The XR Optic hard coating adds scratch resistance for a longer, clearer life.

Safety Note

Wear eye and hand protection and follow safe shop practice when cutting the panel. Leave the protective film on while trimming and cut slowly to avoid chipping.

Fitment Notes

• Works with most hard and soft tops

Tips for a Clean Trim

• Hold the panel against the cage and mark the cut line with a fine marker or tape
• Support the panel on a flat surface so it doesn't flex while cutting
• Use a fine-tooth blade or cutting wheel at moderate speed to avoid melting the edge
• Smooth the cut with a file or sandpaper before installing the seal

The kit uses the same kind of hardware as a direct-fit windshield, so once it's trimmed it mounts just as securely to your cage tubes.

Built for Big Hits

Custom-cage builds tend to be ridden hard. The 1/4-inch polycarbonate takes impacts from large trail debris, and the hard coating keeps the trimmed panel looking clear for years, so your custom work looks finished, not patched together.

What's in the Box

• Hard-coated vented windshield panel, 28" x 40"
• Heavy-duty clamps, bulb seal and hardware

Who It's For and What Pairs Well

For custom builds with a chopped or aftermarket cage. Running a stock cage? A direct-fit full or flip windshield from RZR Turbo S windshields is the easier route.

Fitment

Note: Works with most hard and soft tops

Installation Notes

Mark your cage line on the film, trim with a fine-tooth blade, smooth the edge, then fit the seal and clamps. Take your time: measure twice and cut once.

• Installation instructions (BBWS, PDF)